However, now i have a use for it, and decided to power it up.Changed a 1000 uf cap, as it was bulging and the alarm runs well now.
Resetting Powermax Er Code Manual Says ToA look in the manual says to power it up with a jumper on the RESET pins, but it does not seem to do anything, other than default the system volume, etc. Anyone have a clue, where to start Ive attached an overview picture, if needed I can take more shots. Resetting Powermax Er Code Software May GetOccasionally, the panel software may get corrupted or you may get completely lost in the programming sequences that it is easier and quicker to return the panel to its original factory built state. The factory defaults can be restored by performing a RESET as follows. Remove the panel from its backplate place face down on a cushioned surface. Identify the two left hand jumper pins marked DEF and fit a jumper across them. Remove the battery power, and remove the link from the DEF jumper. Resetting Powermax Er Code Code Can BeVisonic have failed to mention in the installation manual that the user code (default 1111) has to be entered before the installer code can be entered.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |